Connecting a power supply providing more than 5V-DC damages the device! This device allows to exchange data and sms using an UMTS key. Only the central pins 4,5 and 3,6 are switched! Auxiliary pin, leave disconnected if unused connect to 12 V DC in a special BTicino connection scheme in order to provide power to the Microphone line. When no module is present, the analog inputs are not usable. USB connection not available. Jumpers configuration is available only in PCB Ver.

Uploader: Malabei
Date Added: 9 December 2005
File Size: 9.73 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 33368
Price: Free* [*Free Regsitration Required]

The communication is cut off when the called party hangs up or when the interface timer expires. Led indications for Aethra Starmodem. The trimmers allow to regulate the volume of the microphone and the speaker clockwise: This means that the bandwidth is permanently robbed to other devices connected to the same controller; the maximal theoretical USB bandwidth on USB 1.

USB connection not available.

It can be configured as clean contact input default or optoisolated input use voltages in the range 5V – 12V. The status of the relays RA and RB follows the one of the communication. It can be used as backup line when the main one fails, or to establish a connection toward Internet when calling an ISDN number data call back. Physical and electrical specifications.

  GSA-T20N ATA DEVICE DRIVER DOWNLOAD

Auxiliary pin, leave disconnected if unused connect to MIC in a special BTicino connection scheme, ub order to provide power to the Microphone line. Only the central pins 4,5 and 3,6 are switched! This means that the bandwidth is permanently robbed to other devices connected to the same controller.

Each digital output of the IO part is a volt free contact clean contact and can be driven separately by the Abilis. When no module is sfarmodem, the analog inputs are not usable. Auxiliary pin, leave disconnected if unused connect to 12 V DC in a special BTicino connection scheme in order to star,odem power to the Microphone line. Aethra Starmodem which uses the USB isochronous mode for the downstream.

Pins 1,2 and 7,8 are not connected. This timer is not programmable and its default value is 10 minutes.

Citobox – Front view. It is installed on the board and it’s able to switch each LINE port to the correspondent main port or backup port. The IO part offers 8 digital inputs, 4 digital awthra clean contacts and two analog inputs available only if an analog adaptation module is present.

When a continuous or alternate voltage voltange range 2. The PCB version is reported on the case label.

  EPSON ACULASER M2010D DRIVER DOWNLOAD

Each input can be manually configured through its corresponding couple of jumpers. Note Only the central pins 4,5 and 3,6 are switched!

Свежие записи

The digital inputs are general purpose, so they can be used to connect any kind of hardware additional ring buttons, starmoeem sensors, etc. The speaker and the microphone are decoupled by a transformer. This port provides a fast 8-bit bus, where it is possible to connect more slave peripherals. Up to 6 modems can be installed into the same Abilis. After the reset, the procedure starts from point 1.

Citobox trimmers aetha pinout. Abilis is not driving the device. Connecting a power supply providing more than 5V-DC damages the device!

Aethra, SpA. Drivers Download for Windows 10, 8, 7, XP, Vista

Jumpers position on PCB. RJ Switch – Block scheme.

Led indications for Thomson Speedtouch. The digital outputs are relay-based and have 3 volt free contacts i.